Half Way....

After umpteen drill bits and lots of tenacity, we are about half way done with the lock drilling. I went to Home Depot and bought more drill bits so we can finish up today. It is hard work, taking sheer strength to push the drill bit through the cylinder locks...unlike using a cutting wheel to cut padlocks which only takes contact with the area you're cutting and minimal pressure. I was really hoping that I had some type of horizontal drill press that could be wheeled up to each door..line the drill up with the center of the lock and then bore into it....I guess enough money and technology could make anything happen but not to be this go round. More later when our mission has been completed...